Toilet Tips

After a ground-up rebuild of the master bath john (did the other two years ago), I thought I’d give myself a few notes in the event I have to tackle a rebuild again (in this house.)

There are only 3 screws holding the flange down to the floor. There should be 4, but by the time I got there, I didn’t have a screw, so there are still 3.

Because the flange was above the floor by about 3/4″, I did not need the funnel thing in the wax ring I had purchased. (Found this out via YouTube.) That is only needed if the flange is flush (so to speak) with the floor. So I bought another simple wax ring, and that seemed to work better.

The flange bolts were cut so that the cosmetic caps could fit over them. One of the cuts was rough, making it very hard to back the nut off. I had to also cut the new ones, but at least I cut them a bit higher to allow for a file-down if the problem persists with the new bolts. Tip: Buy taller caps?

Don’t use blue cleaner bricks in the tank. They are a mess and seeped into everything. Cleaning up blue gunk from many places.

Stuff some tissue down sewer pipe while working on flange / base to keep gases from coming up into the bathroom and knocking you out.

Leave a Reply

Your email address will not be published. Required fields are marked *